Therma-Stor Products Group owner manual The Phoenix D385 Desiccant Dehumidifier

PO Box 8680 • Madison, WI 53708

Owner’s Manual — Phoenix D385

Installation, Operation & Service Instructions

Read and Save These Instructions

The Phoenix D385 provides the perfect combination of features and performance the restoration industry has been craving in a desiccant dehumidifier. Designed to operate vertically or horizontally, the Phoenix D385 provides the wide operating range and ultra-low grains of a desiccant with the water removal capacity of the largest LGR’s in cabinet dimensions identical to our popular Phoenix

200 Max.

The D385 delivers 385 CFM of ultra-low grain process air and removes an incredible 116 pints per day at AHAM conditions. The true four hole configuration* allows the Phoenix D385 to be located in the affected area with the 75 CFM re-activation air stream isolated from the drying chamber. Three hole designed units** inherently pull unaffected and/or outside air into the drying chamber. The D385’s four hole design allows the restoration contractor to set-up for effective positive, neutral or negative pressure operation.

Able to operate vertically or horizontally, the D385 will fit inside most crawlspaces. Having the D385 securely inside, rather than outside the crawlspace access, deters the

possibility of tampering with the dehumidifier or the set- up. The 385 CFM of process air will provide 3 ACH on an affected area up to 7000 cubic feet.

The Phoenix D385 is easy to transport and set-up. The D385 will fit on your truck in the areas already designed for your LGR’s and will move around the jobsite with the same portability. All the power to the unit is provided by two 115 volt grounded power cords. Simply plug the cords into separate 15 amp circuits. Each cord draws only 11 amps to power the D385. The re-activation air stream is ducted through 6” flex duct provided with the unit and stores conveniently in the top of the unit.

*Having completely separate process and regeneration airstreams. **Where regeneration airstream is pulled from the process airstream.

The Phoenix D385 Desiccant Dehumidifier

•Ultra low grains

•Wide operating range

•116 pints per day @ AHAM

•Operates vertically or horizontally

•Process airflow 385 CFM

•Two 23’ power cords:

11 Amps per cord

22 Amps

115 Volts/60 Hz

•Unlimited ducting possibilities

•Legendary stainless construction

		Phoenix D385
		PN 4026700
		TS-387
Specifications subject to change without notice.		Revised 7/07
Toll-Free 1-800-533-7533		www.usephoenix.com • sales@thermastor.com