Therma-Stor Products Group R175 Safety Certifications, Specifications, Operation, Transporting

Figure 1: Stacked Phoenix R175

Table of Contents
Introduction			1
1.	Safety Certifications		2
2.	Specifications		2
3.	Operation		2
	3.1	Transporting	2
	3.2	Electrical Requirements	2
	3.3	Condensate Removal	3
	3.4	Ducting	3
	3.5	Defrost Cycle	3
	3.6	Power Button	3
	3.7	Purge Button	3
	3.8	Hour Meter	3
	3.9	Hours Button	3
	3.10 Defrost Light		3
4.	Maintenance		3
	4.1	Air Filter	3
	4.2	Storage	4
5.	Service		4
	5.1	Technical Description	4
	5.2	Troubleshooting	4
	5.3	Air Mover	5
	5.4	Thermistor	5
	5.5	Condensate Pump	6
	5.6	Float Safety Switch	6
6.	Options & Accessories		6
7.	Wiring Diagram		6
8.	Service Parts		7
9.	Warranty		9

Read the operation and maintenance instructions carefully before using this unit. Proper adherence to these instructions is essential to obtain maximum benefit from your Phoenix R175 dehumidifier.

•It is designed to be used INDOORS ONLY.

•If used in a wet area, plug it into a GROUND FAULT INTERRUPTER.

•DO NOT use the Phoenix R175 as a bench or table.

•It must always be used in the upright position.

1 Safety Certifications

The Phoenix R175 conforms to standards ANSI/UL 474 and CSA C22.2 No.92.

2 Specifications

Part No.	4026300
Power	6.1 amps, 110-120 VAC, Grounded
Water	92 pints/day @ AHAM (80°F, 60%)
Removal	21 gal/day maximum @ saturation
Blower	230 CFM without external ducting
	210 CFM @ .15 IWG external static
Refrigerant	1 lb, 10 oz. R-22
Charge
Operating	33°F to 105°F
Range
Filters:	12” x 12” x	1” Pleated Media MERV-7
Duct	Intake – 12” Flex-Duct
Options	Supply – 10” Lay-Flat
Warranty	Five years;
	st year 100% of Parts and Labor
	2nd-5th year 100% of Parts of sealed
	refrigeration system.
Dimensions
	Unit	Shipping
Width	20”	24”
Height	33.5”	45.25”
Depth	20”	25.5”
Weight	105 lbs	110 lbs

3 Operation

Place dehumidifier inside structure, place condensate hose into a drain, or a very large container, and turn on. To decrease drying times, make sure all windows and doors are closed to the outside and seal off the wet area from any unaffected areas.

3.1 Transporting

The Phoenix R175 features a high- impact roto-molded housing which protects the unit airways, and while

loading into vehicles. The unit was designed to make it easy to stack two high. The wheels of the top unit ‘nest’ in the indentations of the bottom unit to provide stability. It is recommended the units are properly secured for transport. The Phoenix R175 must always be upright when transported by vehicle. It may be tipped onto its handle and back for loading and moving by hand.

Toll-Free 1-800-533-7533 www.thermastor.com • sales@thermastor.com