Therma-Tru® Light Commercial/Multi-Family - Doors and Frames
| • | Material shown on these drawings will be |
|
| fabricated only after formal approval by the |
|
| architect, receipt of approval hardware schedule, |
|
| and all necessary hardware templates. |
| • All frames shall be shipped | |
|
| unless otherwise specified. |
| • All frames and doors shall be chemically washed, | |
|
| rinsed, and dried prior to receiving one coat of |
|
| paint. |
NOTES | • | Doors and frames will be reinforced for surface |
| mounted hardware as required. Drilling and | |
| tapping for surface mounted hardware shall be | |
|
| applied by others. |
DOOR HANDING CHART
SINGLE DOORS
OUTSIDE |
|
|
| OUTSIDE |
| ||
|
|
|
| ||||
LEFT HAND INSWING |
|
|
| RIGHT HAND INSWING |
| ||
|
|
|
|
|
|
|
|
OUTSIDE | OUTSIDE |
LEFT HAND REVERSE/ | RIGHT HAND REVERSE/ |
RIGHT HAND OUTSWING | LEFT HAND OUTSWING |
PAIRS OF DOORS
• | All standard type hardware will be located at this |
| manufacturer’s standard locations as shown on |
| the door and frame elevations. Hardware items |
| such as panic exit devices, deadbolts, etc. will also |
| be located at manufacturer’s standard locations |
| unless specifically advised. |
• | Installations of all glass and glazing to be |
| performed by others. |
• | Doors, frames, and finished hardware to be |
| installed by others. |
• | Anchor bolts and expansion shields for any type |
| fastener to be furnished by others. |
GENERAL | • | It will be the responsibility of the General |
| Contractor to coordinate hardware locations. | |
|
| |
| • | All frames will be supplied with the required wall |
|
| and floor anchors as illustrated on the frame detail |
|
| sheet. |
| • All frames and doors wll be tagged with shop | |
|
| marks. This schedule can be used to cross |
OUTSIDE
LEFT HAND ACTIVE
OUTSIDE
LEFT HAND REVERSE ACTIVE/
RIGHT HAND OUTSWING ACTIVE
OUTSIDE
RIGHT HAND ACTIVE
OUTSIDE
RIGHT HAND REVERSE ACTIVE/ LEFT HAND OUTSWING ACTIVE
• All frames must be set absolutely plumb, square, |
and level. |
• All frames will be supplied with rubber door silencers: three for single swing openings and two per header for double swing openings.
| reference shop marks with architects marks. |
• | These drawings are not intended for use by other |
| trades. |
• | Field welding, grinding, finishing, and attachment |
| of field splices by others. |
JOB NUMBER:
PROJECT:
LOCATION:
ARCHITECT:
CONTRACTOR:
FINISHED HARDWARE BY:
SHEET NUMBER: | OF |
RECORD OF SUBMITTALS
SUBMITTEDRETURNED
1st
2nd
3rd
4th
RECORDED APPROVED DRAWINGS
RECORDED APPROVED HARDWARE
DRAWN BY:
