d IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT :

INSTALLER:

IMPORTANT:

Important safety instruction

Equipment and usage safety requirements

READ AND SAVE THESE INSTRUCTIONS

THIS APPLIANCE HAS TO BE INSTALLED BY A QUALIFIED TECHNICIAN.

LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE AFTER INSTALLATION COMPLETE.

SAVE FOR THE LOCAL INSPECTOR'S USE.

dWARNING: If the information in this manual is not followed exactly, fire o may result causing property damage or personal injury.

dWARNING: Do not repair or replace any part of the appliance unless spe recommended in the manualsImproper. installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. assistance or additional information, consult a qualified installer, service agenc manufacturer.

Have the installer show you the location of the circuit breaker or fuse. Mar easy reference.

Be sure your appliance is properly installed and grounded by a qualified te

Never modify or alter the construction of the appliance. For example, do no leveling legs, panels, wire covers or anti-tip brackets/screws

Remove all tape and packaging before using the appliance. Destroy de pac after unpacking the appliance. Never allow children to play with packaging

Hidden surfaces may have sharp edges. Use caution when reaching behind under appliance.

Before you plug in an electrical cord, be sure all controls are in the OFF

To eliminate the risk of burns or fire by reaching over heated surface units storage space located above the surface units should be avoided. If cabinet is to be provided, the risk can be reduced by installing a range hood that horizontally a minimum of 5 inches (12.7 cm) beyond the bottom of the ca

This appliance has been tested in accordance with ANSI/UL 858 Standard f Safety for Household Electric Ranges and CAN/CSA-22.2 No.61 National Sta of Canada for Household Cooking Ranges. It is the responsibility of the ow installer to determine if additional requirements and standards apply in specif installations.

Before you begin

Tools and parts needed 1.

2.

Phillips head screwdriver

Pencil

3.Drill with 1/4 • bit

4.Jigsaw

5.Tape measure

4

Page 3
Image 3
Thermador CIT30 Important Safety Instructions, Before you begin, Important safety instruction, Tools and parts needed