Thermador CVS30R 36, CVS36R 45 Care and Cleaning, Or D, Turn Off the blower O, Remove filters

CARE AND CLEANING

The efficiency of the Cook‘n’Vent® downdraft ventila- tion system depends on the cleanliness of the intake and filters. The frequency of cleaning depends on the amount and type of cooking.

•Do not use the ventilating system without the fil- ters in place or with grease-laden filters or surfaces.

To Clean the Intake

Intake must be in the raised position to clean.

1.Turn Off the blower ("O").

2.Grasp the removable front panel at the top near the sides and pull up and then forward. Set aside.

3.Remove filters.

Support Bar	A or D
	E
	C
	0	1	2
			3

Support Bar

Back Wall

B Slats

•Always use the mildest cleaner that will do the job. Use clean, soft cloths, sponges or paper towels.

•Rub stainless steel finishes in the direction of the grain. Wipe area dry to avoid water marks.

•After cleaning, place all parts in their proper positions before using the Cook‘n’Vent®.

The cleaners recommended below indicate a type and do not constitute an endorsement. Use all products according to package directions.

A	Anodized	Top cap is not removable.Wash top and underside with hot sudsy water. Rinse and wipe dry or
	Aluminum	apply Fantastic® or Formula 409® first to a clean sponge or paper towel and wipe clean. DO NOT
	Top Cap for	USE powdered cleansers or steel wool pads.
	Stainless
B	Aluminum	Clean filters in the dishwasher or by agitating in sudsy water. Ensure that there is no soil
	Mesh Filters	trapped in the fine mesh. Dry the filters before reinstalling them.
C	Plastic	DO NOT REMOVE push-button or control knob.Wipe with a moist soapy sponge. Rinse and
	UP/DOWN	dry.
	Push-button,
	Control Knob
D	Painted	Top cap is not removable.Wash top and underside with hot sudsy water. Rinse and wipe dry or
	Top Cap for	apply Fantastik® or Formula 409® first to a clean sponge or paper towel and wipe clean. DO
	Black/White	NOT USE powdered cleansers or steel wool pads.
E	Stainless	Wipe grease accumulation with a paper towel or sponge. Scrape heavy buildup with a plastic
	Steel	spatula. Clean with a soapy sponge; rinse and dry. Always wipe or rub with grain. Wipe with
	Front Panel	Fantastik® or Formula 409® sprayed onto a paper towel. If grease buildup is heavy, several
	& Back Wall	applications may be necessary.
		Polish with Revere Ware® Metal Polish or Stainless Steel Magic® and a soft cloth. Remove
		water spots with a cloth dampened with white vinegar. Use Revere Ware® Instant Stainless
		Steel Cleaner to remove heat discoloration.

To Re-Assemble the Intake

1.Place the filters inside the intake, side by side, on the slats in front of the back wall. They will lean forward and the tops of the outside two will rest against the support bars.

2.Holding the front panel at the top near the sides, place bottom edge over front lower sill of the in- take.

3.Keeping the panel vertical, hook the top of the front panel to the intake.

PAGE 5