Step 5: INSTALLATION
This hood is intended to be mounted onto the kitchen wall.
1.Remove the grease filter (refer to Operating Instructions).
2.Draw a line on the wall from the ceiling to the lower edge of the hood at the center of the location where the hood is going to be mounted.
3.Use the template to mark the points on the wall where the screws will be mounted. In order to make it easier to hook the hood onto the screws, draw the outline of the area where the hood will be attached.
CAUTION – Ensure that the minimum distance between the cooktop and the hood is maintained – 30”. The bottom edge of the template equates to the lower edge of the hood.
4.Drill 2x 1/4” ø holes for the upper fixing bracket and
2x 1/4” ø holes for the lower fixing bracket and press in wall plugs flush with the wall.
Note: At least one screw for the mounting must be installed through a stud.
Step 5: INSTALLATION
Note: Take into account any special accessories that are going to be fitted.
5.Screw on the upper and the two lower mounting brackets.
6.Attach the hood.
Adjust the height and align horizontally with the adjusting screws.
IMPORTANT: Check that the 4 lower fixing holes have been correctly marked. If required, mark again.
PAGE 7
