Thermador HNW installation instructions Cleaning Instructions, Lights, Filters

CLEANING INSTRUCTIONS
Be sure lights are cool
before cleaning the hood.
To Clean Filter/s
• It is recommended that the
filters be washed at least
once a month; they can be
washed by hand or in the
dishwasher.	Fig. 2
• Drain water through holes

along filter edges and allow to	To Replace The Metal Grease
dry thoroughly before	Filter/s
replacing it.	•	Reverse procedure.
To Clean Hood Surface	LIGHTS
• For general care, wipe the	NOTE: Turn blower and lights
outside of the stainless steel,
	off. Make sure the lights are
white, black or glass hood
	cool. If new lights do not opera-
with sudsy water or	te verify lights are inserted
household cleaners such as	correctly before calling service.
Fantastic® or Formula 409®,	Replace Lights For HNW
rinse well and dry with clean
	• Using a flat edge from a
soft cloth to avoid water
		screwdriver or equivalent tool
marks.
		pry loose the lens cover as
• Wipe and dry brushed
		shown in Figure 3.
stainless steel in the same
	• Remove the damaged light
direction as the grain.
		and replace with a new 12
• Do not use abrasive products.
		Volt, 20 Watt (maximum)
• To remove finger prints and
		halogen light made for a G-4
give added shine use spray
		base. Follow package
cleaners such as Stainless
		directions and do not touch
Steel Magic® and Shimmer®
		new light with bare hands.
FILTERS	•	Reinstall the light cover.
The metal grease filters are
made of anodized aluminum and
are long lasting.

To Remove The Metal Grease

Filter/s

• Turn blower and lights off.

•Push each handle towards the back and pull downwards Fig.

2. Fig. 3

Page 5