Thermador P24WK, PC36, PC48 FIG. 5 Side View of Cooktop FIG. 7 Flush to Cabinet Front, FIG. 6 Projecting from Cabinet Front, 7-3/4", 3/4", 26-3/8", 22-5/8" 23-3/8" 2", 12" 1/2", FIG. 8 Installation of 48" Cooktop above two side-by-side Thermador Warming Drawers, Model No. WD24

Plywood support
Install additional
wood support along
front edge of cutout
REAR
2 3/4" (70 mm) minimum
between cutouts
Step 2: Cabinet Preparation
6
Front flush with cabinets;
minimum
of 25-3/8" cabinet depth
required.
FIG. 5 Side View of Cooktop
FIG. 7 Flush to Cabinet
Front
* Provide clearance for screws
by increasing cutout height by
1/16" or by notching in the loca-
tion of the three screws.
FIG. 6 Projecting from
Cabinet Front
Front projects outward 1-3/8" as
shown from standard 24"-deep
base.
1-3/8"
5/8"
Notch
Depth
* Low Back required when there is less than
12" horizontal clearance from back of cooktop to
combustible material. With more than 12" of clear-
ance, the Island Trim may be used.
26-3/8"
22-5/8"
23-3/8"
2"
3/4"
7-3/4"
12"
1/2"
Side Flange
3" TO CENTERLINE GAS
INLET
Cabinet face for installation with projecting control panel
Cabinet face for installation with flush control panel
3"
Side View
7-13/16"
(19,8 cm)
³
³
FIG. 8 Installation of 48" Cooktop above two
side-by-side Thermador Warming Drawers,
Model No. WD24
22-11/16"
(57, 6 cm)
46-1/4"
(117,5 cm)
22-1/2"
(57,2 cm)
7-13/16"
WD24
Cutout WD24
Cutout
13/16"
(21 mm)
2-3/4" (7 cm) Vertical Distance
Between Cutouts
(See Side View for Wood Support)
1-7/8" (4,8 cm)
Horizontal Distance Between Cutouts
Minimum 3/4" (19 mm)
0" to 2"
(0 - 51mm)
See Fig. 4
and Table
Dimension C
(22, 9 cm) 9"
(19,8 cm)
2" Notch
Depth