821 LOW RIDER
1 | Low Rider attaches securely |
to flat surfaces. |
|
| YOUR TRUC |
|
| LEFOR YOU | |
| R | K |
|
| U | RT |
E | F O |
|
|
| T | RU |
|
|
|
|
| C | |
UL |
|
|
| T |
| K |
TH |
|
|
| H | K |
|
|
|
|
| LU | C |
|
|
|
| F | E | UR | T |
| KCURT RUOYRO |
|
| RUOYROFE LU | ||
Recommended Mounting |
|
| ||||
Hardware 1/4" or (6mm) |
|
| ||||
bolts or screws, fender |
|
| ||||
washers, and locking nuts. |
|
| ||||
3 | • Align block with drilled holes. |
|
• Tighten hardware securely. Test installation by pulling and shaking block.
5 | • With lever open, tighten nut |
until the lever closes with |
some resistance.
• Loosen or tighten the nut as needed so that lever closes with some resistance.
2
Use the template below to scribe four drilling points.
• 5/16" (8mm) drill bit recommended.
• Always check handlebar clearance before attaching block.
4
• Set the bicycle forks onto the skewer.
Test security by tugging at forks. If forks can move out of the skewer, open lever and tighten the nut slightly.
Close lever again with firm pressure. Repeat if necessary.
DRILLING TEMPLATE
Drill 4 places using 5/16" or 8mm drill bit
