TIC AMP10 manual Problem, Please Check, No Sound from one speaker, Treble or Bass

Trouble Shooting… (general output devices, speakers)

Problem	Please Check
No Sound	Check the speakers are connected to the cable
	correctly.
	Check the speaker cable is connected to the receiver
	amplifier correctly.
	Check the receiver amplifier is powered “on” at the
	mains, is not on “mute”, has no headphones attached
	and that the Channels used for the exterior speakers
	(usually A or B) is in operation.
	Refer to the owners guide that came with your
	receiver amplifier.
	Most initial problems are connectivity, please try a
	different connection cable to your outdoor speakers
	or equipment.

No Sound from one speaker

One speaker sounds distorted, lower volume or “different”

Treble or Bass

Check the “balance” control on your receiver amplifier.

Check all connections and cable to the inoperable speaker.

1.Disconnect the “working”speaker from the receiver amplifier connection/ channel. Switch the cord from the non-operating speaker from its current connection to the “working” speaker connection. If the speaker now works the problem is your receiver amplifier.

2.Reconnect as original. Remove the speaker cable at the “working” speaker directly and connect it directly to the non-working speaker. If the speaker now works the problem is somewhere in the original speaker cable.

3.If the speaker still does not work the problem is the speaker.

Follow same procedure as above for “No Sound”.

Check the “tone” setting on your receiver amplifier. Adjust the Treble and Bass settings on your receiver amplifier.

Check the connections carefully from the amplifier to your speakers and ensure correct Phase (+ to + and

–to – accordingly). Poor sound replication is expected from a speakers or speakers out of polarity or phase.