PAGE - 5
OPERATION
Be sure the ball valves on the mower hydraulic tank are OPEN before starting the
tractor. Serious damage to the hydraulic system can occur if the valves are not OPEN.
For brush operation: open the high pressure valve located near the pressure port of
the pump and close the high pressure valve located near the electrical solenoid. This
procedure shuts off the oil flow to the mower.
For mower operation: close the high pressure valve located near the pressure port of
the pump and open the high pressure valve located near the electrical solenoid. This
procedure shuts off the oil flow to the brush.
Low brush speed and moderate ground speed will clean almost any hard surface of
all debris. Do not use high brush speeds or dust may be raised by the aggressive action
of the sweeper. Always remember the wind direction and plan your sweeping so it blows
at your back or to the direction that the brush head assembly is angled.
It is usually more effective to plan your sweeping for the days when it is overcast and
humid or on a day after it has rained. By planning in this manner, your dust will be kept
to a minimum.
To sweep gravel, use just enough brush spee to “roll” the gravel and not to throw it.
The sweeper is not a bulldozer!! Do not ram into piles trying to move them as a blade
would.
Remember, the sweeper sweeps with the tips of the broom, not wilth the sides like a
mop. Adjust the spring - chain assembly accordingly.
High brush speeds and low ground speeds are needed to do a good job in snow.
Start with about 3/4 throttle for wetter and deeper snow. This will help to keep the snow
from packing up inside the brush hood.
Just about any amount of snow can be thrown by the sweeper if enough patience
and consideration of the wind direction are used. In deep snow more than one pass may
have to be made to get down to a clean surface.
All Tiger Sweepers are equipped
with adjustable spring assemblies to
limit down pressure. Too often these
springs are removed and thrown away
or ignored. Proper down pressure
should be as pictured to the right.
Check and be sure you are using the
spring assembly. If it is lost or missing,
please order another from the dealer
or factory. If it is on, make sure you
understand and adjust it for poper
usage.
Brush on ground rotating
at normal operating speed
machine stationary.
When lifted, leaves a 2” to
4” clean spot on ground.
CORRECT SWEEPING PATTERN