PAGE - 10
LEVELING INSTRUCTIONS
The sweeper must be leveled t maintain even brush wear and to produce efficient
sweeping action. If the broom is not leveled at first and periodically after that, then it will
put stress on certain parts causing excessive wear. The broom is easily leveled if these
steps are followed.
1. Drive the assembled broom onto a level paved area. Swing the brush head
assembly to the straight position. Lower the brush into the sweeping position with
the weitght of the brush head assembly resting on the ground.
NOTE: all adjustments for leveling are made with bolts “A”, “B”, “C” and “D”.
See illustrations below:
2. Adjust bolts “A” and “B” so both are turned out an equal distance and support an
equal amount of weight. From this point on, bolt “A” and “B” must both be turned
in or out equal amounts to equalize the weight of the head.
3. Adjust bolt “A” and “B” in or out equally as required to level the swing assembly
from front to rear.
4. Raise the brush head assembly about two inches off the ground and angle it fully
to the right. Measure the distance fromthe ground up to the brush head frame at
both ends. See illustration below:
Adjust bolt “C” in Adjust bolt “D” in Adjust bolts “A” & “B” in Adjust bolts “A” & “B” out