•You cannot view the current lap time if Chrono is running.
•Recall data is cleared when Chrono is started from reset.
•iPod function is not available in RECALL mode.
INTERVAL TIMER & TIMER
IPOD FUNCTION IN TIMER & INTERVAL TIMER MODES:
p and U functions share the buttons with important TIMER & INT TMR functions (START and STOP/RESET/SET, respectively):
Timer is: | START/SPLIT Button | STOP/RESET/SET Button | |
Reset | Press and release - START | Press and release | |
(00:00.0) | Press and hold - p | Press and hold - U | |
|
|
| |
Running | Press and release - p | Press and release - STOP | |
Press and hold - p | Press and hold - U | ||
| |||
|
|
| |
Stopped | Press and release - START | Press and release - RESET | |
Press and hold - p | Press and hold - U | ||
| |||
|
|
|
All other iPod functions operate normally.
SETTING THE TIMER or INTERVAL TIMER
You can set one (TIMER) or two sequential (INT TMR) Countdown Timers:
1.Press MODE until TIMER or INT TMR appears. Timer & Interval Timer must be stopped and reset before settings can be changed.
2.Press and release STOP/RESET/SET. [INT TMR ONLY]: INT 1 flashes.
3.Press + / – to change hour.
4.Press NEXT and + / – to set minutes.
5.Press NEXT and + / – to set seconds.
6.Press NEXT and + / – to select STOP AT END or REPEAT AT END.
[INT TMR ONLY]: Press NEXT and then press + / – to change to INT 2 (Interval 2). Press NEXT and repeat steps 3 - 6 for INT 2.
7.Press DONE to confirm and exit.
USING THE TIMER & INTERVAL TIMER
1. Press and release START/SPLIT to start countdown. Countdown will
continue if you exit mode.
An alarm melody chimes when countdown or interval reaches zero or before it starts to countdown again, if set to repeat.
2.Press and release STOP/RESET/SET to stop Timer.
3.Press and release START/SPLIT to continue countdown, or press and release STOP/RESET/SET to reset.
TIPS:
•H appears in Time display when either Timer is running.
•Maximum number of repeats is 99.
•For repeat Timer operation, repetition number appears at top right of screen.
•[INT TMR ONLY] When first countdown is complete, timer proceeds to the next
•[INT TMR ONLY] If you set both Timers in Interval Timer to repeat, Timer will countdown both intervals and then repeat entire sequence.
ALARM
SETTING ALARM
1.Press MODE until ALM 1 appears.
2.Press STOP/RESET/SET to set alarm.
3.Hour digits flash. Press + / – to change hour.
4.Press NEXT and + / – to set minutes, AM or PM (if primary time display is in
5.Press DONE to confirm and exit.
To set remaining alarms, press MODE for ALM 2 or ALM 3 and set as above.
USING ALARM
Press START/SPLIT to turn Alarm ON or OFF. wappears in display when Alarm is ON.
TIPS:
•When Alarm is on and the set time is less than 12 hours away, (alarm icon) appears in Time display.
6 | 7 |
