If you have taken at least one lap:
Press SET. “RECALL” will appear on the display, followed by the lap and split times for Lap 1. Press MODE – “FORMAT” will appear on the display followed by the current display format configuration, which will be flashing. Press START/SPLIT or STOP/RESET to select the desired format and then press SET to save the setting and return to the Chronograph display.
Reviewing Stored Lap/Split Times
1.In CHRO mode, press SET to begin. If there are lap/split times stored, “RECALL” will appear on the display, followed by the lap/split time for Lap 1.
NOTE: If there are no lap/split times to recall, the watch will display “FORMAT” and allow you to change the display format (see “Changing the Display Format” above).
2.Press START/SPLIT to view each successive lap/split time, followed by the BEST and AVERAGE lap
(if the Chronograph is stopped). You may also press STOP/RESET to go back and view earlier lap/split times.
NOTE: You may recall the stored timing information while the Chronograph is running or stopped, as long as you have taken at least one lap. If the Chronograph is stopped, the BEST and AVG information will follow the last entry; if the Chronograph is still running, these data are not shown.
3.When you have finished reviewing the lap/split times, press SET to return CHRO mode.
NOTE: You may also change the display format for CHRO mode while viewing stored lap/split information. Press
38 | 39 |
