Timex 805-095003, W240 NA manual Basic Operations, iPod CONTROL, Tips, G iPod NANO & iPod CLASSIC

BASIC OPERATIONS

3.Press p button, ensure iPod responds to the command correctly. If not, remove receiver from iPod and repeat steps 2 and 3 until iPod responds correctly.

You are now ready to wirelessly control your iPod with your watch!

INDIGLO® BUTTON

STOP/RESET/SET OR DONE (To save changes and exit setting)

MODE OR NEXT

(Proceed to next step)

VOLUME UP

OR Increase value.

Hold to increase rapidly

NEXT TRACK

OR Proceed to next step

VOLUME DOWN

OR Decrease value.

Hold to decrease rapidly

START/SPLIT

TIPS:

•Qwill be visible on display in modes where iPod use is possible (TIME, CHRONO, INTERVAL TIMER and TIMER modes).

•There will be a slight delay in the iPod's response to button presses on the watch. This is normal.

3 G iPod NANO & iPod CLASSIC:

•	Your iPod may exhibit a slightly longer delay when responding to
	iControl® watch commands.
•	The volume level will not be displayed when changing volume using
	your iControl® watch.

When setting, each button has a different function as indicated above.

Display indicates when button changes function.

	iPod CONTROL
iPod® ICON
	VOLUME UP
PREVIOUS TRACK
(Refer to Mode	NEXT TRACK
descriptions for
operation)
	VOLUME DOWN
	PLAY/PAUSE
	(Refer to Mode
	descriptions for
	operation)

GETTING STARTED WITH YOUR iControl® WATCH

Perform these steps each time you are attaching the receiver device to your iPod to ensure reliable operation:

1. Press MODE until watch is in TIME mode. Qwill be visible on display.

2. Plug receiver into iPod dock connector.

• Fast-forward or reverse through the currently playing track is not

available, therefore holding U or u watch buttons has no effect.

• It is not possible to turn your iPod off by holding p button.

• The iControl® watch is designed to operate up to a range of about 10

ft. (3 m). Range will be affected by watch and iPod battery voltage. If

range is greatly reduced even with iPod fully charged, it may be nec-

essary to replace watch battery. Refer to battery change instructions

at the end of these instructions.

• Receiver is powered by iPod, therefore use of the iControl system

will reduce time between charges for the iPod. Unplug receiver from

iPod when not using the iControl system.

3 G iPod NANO ONLY:

•The backlight may cause interference with iControl® operation, especially with backlight timer settings greater than 10 seconds. If iControl® operation is unreliable when the backlight is on, try reducing the Backlight Timer setting. This setting can be found in the settings menu on the iPod.

iPod TOUCH ONLY

•The volume will increase or decrease two steps for each press of the iControl® volume up (+) or volume down (–) key.

2 3