11. SECURING THE TWINBREEZE BRACKET TO THE BASE OF THE TIVO
Insert a metal washer onto each of the two remaining self- tapping screws. Use one hand to push the bracket down. Using your other hand, lift the left edge of the TiVo. Using Figure 17 as a guide, locate the
Be sure that the bracket mounts are aligned properly – counting from the gap between the sets of holes, you should be screwing into the fourth hole towards the back, and the third hole towards the front. If the bracket isn’t sitting there, you may need to adjust its position a bit to get it there.
Once you have the bracket aligned, insert the |
|
screws through correct hole in the bottom of the TiVo and |
|
into the | Figure 17 (above) Bottom left side view |
Gently tighten the screws in place. Do not overtighten. |
|
Once you have secured the bracket using the two self- |
|
tapping screws, your TiVo should look like Figure 18. |
|
Figure 18 (above)
12. RE-ATTACHING THE TIVO LID
Place the TiVo lid back over the TiVo. Align the clips on each side of the lid so that they clip down on the sides of your TiVo. Slide the lid toward you while simultaneously pushing gently down on the top of the lid. See Figure 19. Once the lid is in place, reattach the five Torx screws. Plug in your TiVo and enjoy!
You can verify your new capacity by looking in the System Information screen of your TiVo. The System Information screen is located in the “Messages and Setup” menu. Once in the System
Information screen, you will see “Variable up to XXX hours” (you
may have to scroll down the page using the “channel down”Figure 19 button). This message gives you the maximum capacity of your
unit, after the upgrade..
We thank you very much for your purchase and hope that you enjoy your