Tivoli Audio MUSIC SYSTEM owner manual English, Figure

English

3.PRESETS 1– 6: Press and hold to memorize the tuned station to that particular preset. A beep will sound confirming the station has been successfully stored. Press briefly to recall the station associated with that preset. There are 6 FM presets and 6 AM presets. If a Preset button is pressed but no station has been set, the display will show “Preset Empty” for

2 seconds. These buttons will also act as limited direct track access during CD playback. The same station cannot be saved to more than 1 preset. Note the remote control’s 1 through 6 buttons cannot be used to save favorite stations to the presets, only recall them after they have been saved using the Music System’s front panel buttons.

4.SOURCE: Briefly press to cycle through the four sources: FM, AM, CD, and Auxiliary. The source can’t be changed while the alarm is sounding. If the source is changed during CD playback and the source is changed back to CD again, the CD will start playback from the first track.

5.SLEEP: With the Music System playing FM, AM, CD, or an auxiliary device, briefly press to begin the 20 minute Sleep timer. The corresponding green LED will illuminate while the Sleep timer is active and the display will countdown the remaining Sleep time. The Music System will power off automatically at the end of the Sleep cycle. Sleep cannot be activated in CD mode unless a CD is loaded. Note RDS and CD Text will not be displayed in Sleep mode.

6. / TUNE +/–:Briefly press to advance to the next track on a disc or back to a previous track if the track has been playing for under 10 seconds. If the track has been playing for more than 10 seconds, pressing the button will re-start the currently playing track. Using these buttons during shuffle play may cause tracks to repeat. When listening to FM or AM, press briefly to change the frequency up or down. Press, hold, and release to seek for the next strongly received station. Press and hold to quickly advance through the frequencies.

7.STOP: Press to stop CD playback and return to the first track.

8.PLAY/PAUSE: With a CD loaded, briefly press to initiate disc playback. Press during playback to Pause playback and press again to resume playback. If the CD is paused for more than 5 consecutive minutes it will revert to Stop.

9.: Briefly press to fast forward or fast reverse in approximately 10 second intervals. Press againto resume normal playback or press Play. These functions are not on the remote control. Due to the nature of MP3 CDs, using the fast reverse will cause the CD to stop play- back once it reaches the start of the track. Also note fast forward and fast reverse will not

operate during CD Intro mode. Pressing the fast scan buttons () during shuffle play may cause tracks to repeat.

10.EJECT: Press to Eject a CD. The display will show “Ejecting”. This button is to eject only and should NOT be used to load a CD. Always remove the disc in a straight position with- out bending the disc. In the unlikely event you experience an error or a disc remains stuck inside, disconnect the power cord for 60 seconds and reconnect firmly.

Figure 6 Figure 7