3EC17766 BAAA TCZZA Ed. 01
3 Troubleshooting and Specifications
46
How to perform a
hardware reset to
factory defaults
Proceed as follows:
Resetting the system to its factory defaults also involves deleting the configuration
profile settings. You may, therefore, need to reconfigure the system using the Speed-
Touch™ Setup wizard or by uploading the relevant configuration file. See section
“1.4 SpeedTouch™570 Configuration Setup” on page18 for more infor mation.
In case you made a back up file of the last known good configuration, you can use it to
restore the SpeedTouch™570 configuration. See “ Upgrade” on page 34 for more infor-
mation.
Factory default service
settings
When the SpeedTouch™570 leaves the factory and after every hardware reset to
defaults, the SpeedTouch™570 features the following factory default settings:
•Default IP configuration:
•IP address: 10.0.0.138
•System password: not set
•DHCP server: disabled
•DNS server: disabled
•Master firewall: enabled
•Default wireless acces point configuration:
•SSID: SpeedTouchXXXXXX (where XXXXXX is the last 6 characters of
the SpeedTouch™570's WLAN access point MAC address).
•DSSS radio channel number: automatic selection on each restart
•Association Control List: empty and locked
•Registration button: enabled
•64-bits/128-bits WEP encryption: disabled
•Default Connection profile settings:
•IEEE802.3D Transparent Bridging on VPI*VCI=8*35
•IEEE802.3D Transparent Bridging on VPI*VCI=0*35
Step Action
1Make sure the SpeedTouch™570 is powered on.
2Use a pencil to press the Defaults button at the back of the SpeedTouch™570
until all the LEDs on the front of the SpeedTouch™570 start flashing.
3Release the button. You will notice that the SpeedTouch™570 reboots. The
SpeedTouch™570 will come online with factory default settings.
You will need to re-associate and register your WLAN clients, using the
factory defaults WLAN settings. See subsection “1.3.1 First-time Wireless
Client Connectivity” on page 15.