TANNOY is52
4.0 UNPACKING
Carefully open the shipping carton and check for any noticeable damage. Every Tannoy is52 is tested and inspected before leaving the factory and should arrive in perfect condition. If found to be damaged, notify the shipping company immediately. Only the consignee may institute a claim with the carrier for damage incurred during shipping. Be sure to save the carton and packing materials for the carriers inspection.
It is also advisable to save the carton and packing material, even if the speaker is undamaged. Should you ever need to ship the loudspeaker, always use original packaging.
5.0 INSTALLATION
5.1 Installation with back can
1.Lay the loudspeaker cable from the amplifier to the cavity where the loudspeaker will be installed.
2. Thread the cable or conduit through the appropriate entry point on the back can. There are six entry points to choose from.
3. Plug the remaining entry points with the supplied grommets to ensure that the back can is water tight. The grommets need to be hammered into the back can.
4. SAFETY NOTE: If the back can is being installed into a concrete cavity, it is the responsibility of the installer to follow the relevant safety precautions.
5. Terminate and connect the loudspeaker. Go to section 6.0 Connections for wiring and connection instructions, then return to point 6 below.
6. Place the back can into the cavity.
7. Affix the loudspeaker to the back can using the supplied fittings. See fig 1.
8. Attach the grille using supplied fittings. See fig 2.
IMPORTANT care must be taken not to over tighten the screws, as the grille is mounted on rubber spacers.
fig 1. | fig 2. |
5
