ASSEMBLY INSTRUCTIONS

ALWAYS MAKE SURE THE JUICER IS UNPLUGGED

BEFORE STARTING TO ASSEMBLE.

STEP ONE: Place Juice Bowl

Position the Juice Bowl on top of the Motor Base so that the Juice Spout is to the right. Lower the Juice Bowl onto the Motor Base so that the Juice Spout slides through the oval ring in the Motor Base.

STEP TWO: Place Filter Basket

With both hands, grasp the rim of the Filter Basket and center it over the Motor Base Hub inside the Juice Bowl. Carefully lower the Filter Basket onto the Hub, rotating slightly until it drops into the proper position; then press firmly down on the rim of the Filter Basket to secure. (Be sure to apply pressure the both sides of the Filter Basket evenly to ensure proper seating.) When seated properly, the Filter Basket will spin freely and will not lift out of the Juice Bowl.

CAUTION: Use care when handling the Filter

Basket; the Cutting Blades are very sharp!

STEP THREE: Place Lid

Place the Lid onto the Juice Bowl so that the

Pulp Ejection Opening is positioned over the

Pulp Spout.

STEP FOUR: Attach Feed Tube

Center the Feed Tube over the Lid opening so that the safety-lock hook on the Feed Tube is is slightly clockwise from the arrow on the Lid. Insert the three tabs located around the bottom of the Feed Tube into the three corresponding slots in the Lid opening, then rotate the Feed Tube counterclockwise until the safety-lock tab on the Feed Tube aligns with the arrow on the Lid.

11