
1.Carefully place the Rubber Seal Ring over the Blade Assembly.
2.Place the Blade Assembly in the Blending Jar, turning the Blade
Assembly clockwise to tighten.
NOTE: The Blade Assembly must be firmly attached to the Blending Jar before putting any foods or liquids into the Blending Jar.
3.Place the Blending Jar with Blade Assembly into the Motor Housing by lining up the arrow on the Blending Jar with the UNLOCK on the Motor Housing. Turn the Blending Jar to the right so that the arrow on the Blending Jar is lined up with the arrow in the LOCK position on the Motor Housing. (See Figure 2.)
UNLOCK position
LOCK position
Figure 2
Operating Instructions
CAUTION: Keep hands and utensils out of the Blending Jar while blending to prevent the possibility of severe injury to persons or damage to the unit. A scraper may be used but must only be used when the unit is not running.
CAUTION: Use extreme care when handling the Blade Assembly. Do not touch Blades with your fingers. The Blades are very sharp and can cause injury if touched.
1.Before starting, make sure power cord is unplugged and the Speed Control Dial is turned to “0”, the OFF position.
2.Make sure that the Blade Assembly and Rubber Seal Ring are properly assembled and securely fastened to the Blending Jar. See Blender Assembly Instructions for details.
3.Lock the Blending Jar on top of the Motor Housing making sure it is firmly seated and not tilting to one side. See Blender Assembly Instructions for details.
CAUTION: Never place the Blade Assembly on the Motor Housing without the Blending Jar being completely assembled and securely tightened.
4. | Add ingredients to the Blending Jar. |
|
|
5. | Place Blending Jar Lid with Measuring | Handle | Locking |
| Cap on Blending Jar. Turn the | ||
| Notch | ||
| Blending Jar Lid so that the Locking |
| Tab |
|
|
| |
| Tab of the Lid fits securely into the |
|
|
| notch in the top of the Handle. |
|
|
| (See Figure 3.) |
| Figure 3 |
4