Toastmaster TEK17W GETTING STARTED, Before Using Your Cordless Kettle, Boiling Instructions

GETTING STARTED

Before Using Your Cordless Kettle

Carefully unpack your Kettle and remove all packaging materials. Place your Kettle on a level surface such as a countertop or table.

Thoroughly clean your Kettle before using. Remove Kettle from the Power Base. Fill the Kettle to its maximum capacity (1.7 Liters) with water and boil. See boiling instructions. When the unit shuts off, discard the water. Wait ten minutes to allow the heating element to cool. Rinse the Kettle out with cold water. Repeat this process two more times.

Boiling Instructions

1.Place Power Base on a level surface such as a countertop or table. The Power Base must be dry before use. Unwind the power cord from the cord storage area located beneath the Power Base. Make sure the cord exits through the Cord Exit on the side of the Power Base.

2.Raise the ON/OFF Lever into the OFF position. (See Figure 2).

3.Remove Kettle from the Power Base.

4.Open the Lid by pressing the Lid Release Buttons together and lifting up. (See Figure 3). Fill the Kettle with the desired amount of water,

between at least the minimum 0.5 Liters and the maximum

1.7Liters. Close the Lid and wipe excess water off the Kettle.

NOTE: If the Lid is not properly closed, the Kettle will not automatically shut off.

5.Place the Kettle on the Power Base, engaging the connector into the bottom of the Kettle. Be careful not to spill

any water onto the Power Base.

FIGURE 2

FIGURE 3

5.