Toastmaster TMBL2 BLENDER ASSEMBLY INSTRUCTIONS, OPERATING INSTRUCTIONS

BLENDER ASSEMBLY INSTRUCTIONS

NOTE: Before assembling, make sure the cord is unplugged.

CAUTION: Use extreme care when handling the Blade Assembly. Do not touch Blades with your fingers. The Blades are very sharp and can cause injury if touched.

1. Carefully place the Rubber Seal Ring over the Blade Assembly.

2. Place the Blade Assembly in the Blending Jar by lining up the two tabs on the side of the Blade assembly with the two slots on the Blending Jar (see

Figure 2). Figure 2

3.Push up and turn the Blade Assembly clockwise to firmly secure it into position on the Blending Jar. To remove, turn Blade assembly counterclockwise and pull down.

4.Carefully place the Blending Jar over the Motor Housing by aligning the notches on the bottom of the jar with the grooves in the base.

5.Once Blending Jar is in place, turn clockwise until the Blending Jar locks into position.

NOTE: The Collar and Blade must be firmly attached to

the Blending Jar before putting any foods or liquids into the Blending Jar.

OPERATING INSTRUCTIONS

CAUTION: Keep hands and utensils out of the Blending Jar while blending to prevent the possibility of severe injury to persons or damage to the unit. A scraper may be used but must only be used when the unit is not running.

CAUTION: Use extreme care when handling the Blender Blade. Do not touch Blades with your fingers. The Blades are very sharp and can cause injury if touched.

1.Before starting, make sure power cord is unplugged.

2.Make sure that the Blade Assembly, Rubber Seal Ring, and Collar are properly assembled and securely fastened to the Blending Jar. See Assembly Instructions for details.

3.Place the Blending Jar on top of the Motor Housing making sure it is securely locked into the Motor Housing.

5