Topcom 101 - page 14

1INSTALLATION

Youcan use batteries or an AC adaptor to activate the telephone display. When you install the batteries,

the telephone lines at the back of the phone have to be disconnected.

To insert the batteries, take the following steps :

•Use a screwdriver or any other flat tool to open the battery compartment.

•Put four 1,5V (AAA) batteries inside the battery compartment.

• Close the battery compartment carefully.

Note :When the “Battery empty” symbol appears on the display, the batteries need to be replaced by new ones.

To install the phone, you have to do the following :

•Connect one end of the telephone cable to the Clip Phone 101 and the other end to the receiver.

•Connect one end of the telephone line to the back of the phone “LINE” and the other end to the

telephone line wall socket.

2 BUTTONS

1 Numerical buttons

2 Memory button

3 Memo button

4 Recall button

5 Erase button

6 Down button

7 Up button

8 Pause button

9 Mute button

10 Flash button

11 Redial button

12 Direct Memory button M1

13 Direct Memory button M2

14 Direct Memory button M3

15 Direct Memory button M4

16 Direct Memory button M5

17 Ring volume switch

18 Volume switch

Clip Phone 101