Butler 3055

‘NEW CODE’ appears on the display.

Enter the new PIN code in. Use the number keys.

Press the Programming key .

‘AGAIN’ appears on the display.

Enter the new PIN code again. Use the number keys.

Press the Programming key .

You hear a confirmation tone. The new PIN code has been set.

Caution : Do not forget your personal PIN code. If you do, you have to restore the default settings

(reset – see section 4.32).

4.24Subscribing a handset to a Butler 1000, 1010, 1210, 2405, 2410, 2450, 2455, 30xx base unit

In order to be able to make and receive telephone calls, a new handset has to be subscribed to the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is sub- scribed as handset 1 on the base unit upon delivery (base unit 1).

!!! You only need to subscribe the handset if: !!!

• the handset subscription has been removed from the base unit (e.g. for reinitialisation)

• you want to subscribe a different handset to this base unit.

The underlined procedure is only applicable to a Butler 1000, 1010, 1210, 2405, 2410, 2450, 2455, 30xx handset and base unit!!

Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator

on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly for one minute. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the handset:

• Press the Programming key .

• Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.

• Press the Programming key .

• ‘BASE _‘ appears on the display.

• Enter a number of the base unit you would like to subscribe the handset to (1-4). Use the number keypad.

Note: Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit number. It is best to use ‘1’ .

‘SEARCHING’ and the symbol appears on the display.

The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds when the handset has found the base unit.

Press the Programming key .

‘PIN’ appears on the display.

Enter the 4-digit PIN code of the base unit in (default PIN code is ‘0000’). Use the number keypad.

Press the Programming key .

The handset is subscribed to the base unit.

156

Page 156
Image 156
Topcom 3055 manual 156