Topcom Butler 4112
Keep the Paging key 
on the base unit pressed for 10 seconds until The Line/Charge
indicator 
on the base unit begins to blink rapidly. The Line/Charge indicator 
will blink rapidly for one minute. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the handset:
•Press the Programming key 
.
•Press the Up or Down key 
repeatedly until ‘BASE SUB’ appears on the display.
•Press the Programming key 
.
•‘BASE _‘ appears on the display.
•Enter a number of the base unit you would like to subscribe the handset to
•‘SEARCHING’ and the symbol 
appears on the display.
Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit number. It is best to use ‘1’.
•The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds when the handset has found the base unit.
•Press the Programming key 
.
•‘PIN’ appears on the display.
•Enter the
•Press the Programming key 
.
•The handset is subscribed to the base unit.
4.24 Subscribing Butler 4112 handset on another base (other brand/model)
Put the base in subscription mode (see manual of the base). If the base is in subscribing mode, you have to do the following to subscribe the handset:
•Press the Programming key 
.
•Press the Up or Down key 
repeatedly until ‘BASE SUB’ appears on the display.
•Press the Programming key 
.
•‘BASE _‘ appears on the display.
•Enter a number for the base unit to which you would like to subscribe the handset
•Use the number keypad.
•‘SEARCHING’ and the symbol 
appear on the display.
•The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds once the base unit is found by the handset.
•Press the Programming key 
.
•‘PIN’ appears on the display.
•Enter the
•Press the Programming key 
.
•The handset is subscribed to the base unit.
20 | Topcom Butler 4112 |
