26 PreferenceSettings
mode is configurable later on by using the sound button
on your remote control.
RF Output
When the digital receiver is connected to the TV by an RF ca-
ble, you may need to select the correct TV standard system.
Select the PALG,PAL I,PALK,NTSC M mode by using ,
buttons.
RF Channel
Select a RF channel by using , buttons. The default RF
channel is CH36. When you change the RF channel number,
you must also change to the same value on the TV.If you do
not, there will be no pictureand sound.
3.6 Menu Display Transparency
To adjust the transparency level of the menus and the other
on-screen display , select the System Setting >OSD Trans-
parency menu. The available levels are ranging from 0% to
50%.
3.7 Display Time of The Information Box
Refer the information box to Section 5.2 on page 32.
To adjust the display time of the information box, select the
System Setting >Info Box Display Timemenu. When you se-
lect a service to watch, the information box is displayed dur-
ing the specified time.
3.8 Position of The Information Box
Youcan raise or lower the position of the information box.