THROTTLE CONTROL LEVER
The throttle control lever is located on the right side of the tractor’s dash panel. This lever controls the speed of the engine and, on some models, when pushed all the way forward, the choke control also. When set in a given position, the throttle will maintain a uniform engine speed. See Figure 5.
Choke |
|
|
|
|
| Fast |
|
|
|
| |||||
Position |
|
|
| ||||
|
|
| Position | ||||
|
|
| |||||
|
|
|
|
|
| ||
Fast
Position
Slow | Slow |
| |
|
| Position | |
Position | |||
Figure 5
IMPORTANT: When operating the tractor with the cutting deck engaged, be certain that the throttle lever is always in the FAST (rabbit) position.
CHOKE CONTROL
The choke control can be found on the left side of the dash panel and is activated by pulling the knob outward. Activating the choke control closes the choke plate on the carburetor and aids in starting the engine. Refer to STARTING THE ENGINE in the OPERATION section of this manual for detailed starting instructions.
BRAKE PEDAL
The brake pedal is located on the right front side of the tractor above the drive pedal along the running board. The brake pedal can be used for sudden stops or setting the parking brake.
NOTE: The brake pedal must be fully depressed to activate the safety interlock switch when starting the tractor.
IGNITION SWITCH
WARNING: Never leave a running machine unattended. Always disengage PTO, move shift lever into neutral position, set parking brake, stop engine and remove key to prevent unintended starting.
To start the engine, insert the key into the ignition switch and turn clockwise to the START position. Release the key into the NORMAL MOWING MODE position once the engine has fired.
To stop the engine, turn the ignition key counterclockwise to the STOP position. See Figure 6.
Normal
Driving
Mode
Stop 
Position
Start
Position
Figure 6
IMPORTANT: Prior to operating the tractor, refer to both Safety Interlock Switches, page 13 and Starting The Engine, page 14 of this manual for detailed instructions regarding the Ignition Switch Module and operating the tractor in
REVERSE CAUTION MODE.
DRIVE PEDAL
The drive pedal is located below the brake pedal on the right front side of the tractor along the running board. Depress the drive pedal with your right foot when the tractor shift lever is in either FORWARD or REVERSE to
cause the tractor to move. Ground speed is also
controlled with the drive
pedal. The further down the pedal is depressed, the faster the tractor will travel. The pedal will return to its original position when it’s not depressed.
IMPORTANT: Always set the parking brake when leaving the tractor unattended.
11
