TORO GM 345 / 325-D Cutting Unit Drive

Notes
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________

73

Troubleshooting
1. Poor cutting unit performance:
Drive belt slipping.
Tighten the drive belt.
Adjust PTO belt tension spring to 3 3/16 in.(80.96 mm).
2. Drive belt failure:
Improper belt alignment.
Align drive belt.
NOTE: See the operators manual or the service manual for the complete adjustment procedure.