7
2.Remove the cap and spool.
Note: If the spring falls off, install it before installing the spool.
3.Thoroughly clean the cutting head and cap
and inspect them for any m6304 damaged or worn parts.
Rewinding the Spool
Note: If you are replacing the spool with a new,
1.Remove any cutting line left on the spool.
2.Hook one end of line
all the way into the slot on the spool, allowing no more than 1/8 inch (3 mm) to protrude.
3.Wind the line in the direction of the arrow on the spool, in level rows, between the spool flanges.
Note: The trimmer will not function correctly if you wind the line in the wrong direction, the end of the line protrudes more than 1/8 inch (3 mm), or you wind more than 30 ft of line on the spool.
Installing the Spool
Caution
If you do not fully install the spool and cap, the trimmer could throw them during operation, causing injury to you or bystanders.
2.Holding the line and spool, place the cap over the spool.
3.Twist the cap on securely clockwise.
Maintenance
After each use of the trimmer, complete the following procedures:
•Wipe the trimmer clean with a damp cloth. Do not hose the trimmer down or submerse it in water.
•Wipe or scrape clean the cutter head and spool area any time there is an accumulation of dirt or cuttings.
•Check and tighten all fasteners. If any part is damaged or lost, repair or replace it.
•Brush debris away from air intake
vents.
Ensure that you fully install the spool and cap.
1.Holding the line and spool, insert the spool into the cutting head and the line into the eyelet.
Important: Keep the air intake vents free of grass and debris to prevent the motor from overheating.
Storage
For idle periods of more than a month, disconnect the charger from the wall outlet and trimmer after the trimmer is fully charged. Do not store the trimmer with the charger plugged in. Storing trimmer in a warm area will decrease life of battery. If the trimmer must be stored in a warm area, charge battery for 24 hours every 2±3 months when not in use.
3329±341
