6

Adjusting the Maximum Line Length

You can change the maximum length of the cutting line to either cut just inside the metal wire guide (for trimming next to plants and structures that would be damaged by the line) or to extend past the guide at the full cutting swath (for general trimming and edging).

Caution

The blade under the guard is sharp and can cut you. Be careful when handling the trimmer so that you do not accidentally cut yourself.

To shorten the line to cut just inside the wire guide, push in on the red knob on the guard and turn it counterclockwise.

m±5791

To lengthen the line to cut outside the wire

guide at the full 10 inch (25 cm) cutting swath,

push in on the red knob

on the guard and turn it

clockwise.m±5791

After changing the knob setting, run the trimmer as normal, advancing the line by tapping the spool on the ground.

Operating Tips

To reduce line wear and improve trimming performance, use the following techniques when trimming:

Warning

When the trimmer is running the cutting head is spinning. If you contact the cutting line or cutting head, you could be injured.

￿Keep the cutting head away from your feet and bystanders.

￿Wear shoes and long pants when using the trimmer.

￿Ensure that the cutting head has stopped before you service or examine the cutting head. Do not start the trimmer unless your hands are on both handles and the cutting head is down near the ground.

Warning

During operation, the trimmer may throw objects in the operator's or a bystander's direction, causing injury.

￿Wear safety goggles or other suitable eye protection, long pants, and shoes while operating the trimmer.

￿Keep people and pets away from the trimming area.

Remove any wire, rope or string-like matter which could become entangled in the rotating line from the trimming area.

Trim only when the grass and weeds are dry.

Slowly move the trimmer in and out of the area being cut.

Cut grass in excess of eight inches tall or weeds from the top to the bottom in small increments.

Do not force the trimmer. Allow the very tip of the line to do the cutting.

Replacing Line

For replacement line, you can purchase either a new, pre-wound spool of line (model no. 88175, 88052, or 88035) or bulk line (0.065 inch dia. (1.6 mm) x 30ft.

(9 m)) that you can wind onto the old spool. Both are available from your Authorized Toro Dealer.

Caution

Metal wire, rope, plastic knives, or any material other than Toro .065 inch dia. (1.6 mm) nylon monofilament may overload the motor, possibly causing a fire or electrical shock.

Do not use any material other than Toro .065 inch dia. (1.6 mm) nylon monofilament, 30 ft. (9 m) maximum line length.

Removing the Spool

1.Twist the cap off counterclockwise.

m￿6302

3329±341

Page 6
Image 6
Toro 51465230000001 & Up manual Adjusting the Maximum Line Length, Operating Tips, Replacing Line