Lever for adjustment of cutting height, Seat | Husqvarna Rider 16

PRESENTATION

Lever for adjustment of cutting height

With this lever the cutting height can be adjusted to 9 different positions (4-90 mm, 45-80 mm Bioclip).

Cutting unit with side/rear ejector, 40-90 mm.

BioClip cutting unit, 45-95 mm.

Seat

The seat has a jointed attachment on the front edge and can be tipped forward.

The seat can also be adjusted lengthways.

Release the knobs under the seat and adjust it forwards or backwards to the required position.

Lock the setting with the knobs.

Fuelling

The engine should be run on 85 octane (or higher) unleaded petrol/gasoline (no added oil). Environmentally adapted alkylate fuel, such as Aspen, is also recommended.

WARNING! Petrol/gasoline is highly inflammable. Observe care and fill up with fuel outdoors (see safety instructions).

14 – English

Image 15

Husqvarna Rider 16 manual Lever for adjustment of cutting height, Seat, Fuelling

Contents

101 91 Rider Contents II. Slope operation Safety InstructionsSafe operation practices for ride-on mowers General operation IV. Service Dear customer Instruction Good service Serial numberEngine Transmission Explanation of Symbols Reversing General use Do as follows Driving on slopes Children Maintenance Battery can explode and cause severe injuries Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Lift lever for cutting unit Cutting unit Lever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engine Hours Before start 100 MaintenanceMaintenance schedule Daily Maintenance interval Right-hand fender Dismantling of the machine hoodsEngine hood Front hood Checking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wire Replacing the air filter Do not use compressed air to clean the paper filter Check the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressure Fitting the cutting unit Installing BioClip Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unit Replacing the belts on a BioClip unit Replacing the cutting unit belts Important Imformation Placing in service position Service position for cutting unit Maintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Lubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Problem Procedure Trouble Shooting Schedule Service StorageWinter storage Technical Data EU declaration of conformity Only applies to Europe Work done Date, mileage, stamp, sign Servicejournal RiderPre-delivery service After first 5 hours Servicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03