Muratec F-100, F-150, F-120 manual Attach the paper-handling parts, Plug in and power up, Tel Mode

Getting started

Attach the paper-handling parts

1 Attach the document tray by inserting it into the appropriate holes, as shown.

2 Attach the paper hopper into the appropriate hole, as shown. Press gently until the hopper won’t go in any farther.

3 Attach the document hopper by inserting its two pegs at a slightly upward angle into the appropri- ate holes, as shown.

	Document
Paper hopper	hopper

Plug in and power up

1 Plug one end of the telephone line cord into the LINE jack on the machine’s rear side. Plug the other end of the cord into a standard tele- phone wall jack, just as you would plug in a phone.

Note: If you have purchased an

optional handset, do not confuse its curled handset cord with the uncurled telephone line cord.

Note: We’ll get to the HANDSET and EXT.TEL jacks shortly (see page 1.9).

2 Plug the non-pronged end of the AC power cord into the AC power cord jack on the left side of the machine (as viewed from the machine’s front).

3 Plug the pronged end of the AC power cord into a 120 VAC electrical outlet (preferably on a surge suppressor, as mentioned on page 1.6).

4 Use the AC power switch to turn on your machine. The markings are international standards: I means on, O means off.

Setting the paper size for the multipurpose tray

The multipurpose tray can hold either letter- or legal-sized paper for your machine. All you have to do is tell the machine which size the tray is using.

Important: The paper cassette (as opposed to the tray) uses only letter-sized paper.

Important: If you use a different size from the size you set here, the machine won’t print; so perform this setting whenever you load a different size.

1 Press /PROGRAM, J, 0, 4, ENTER. The LCD shows the tray’s current setting:

Paper Size: Letter

Program/Enter

If the setting you see is acceptable, skip to step 3.

Otherwise, proceed to step 2.

2	To change the setting, press or /PROGRAM once or twice until your chosen
	paper size appears. In this example, we’ve chosen legal-sized paper.

Paper Size: Legal

Program/Enter

3 Press ENTER to save the setting.

Adjust the monitor speaker’s volume

You can set the volume of the monitor speaker, assuring that on-hook dialing will be as loud (or as soft) as you require.

1 Press MONITOR/CALL on the control panel. You now should hear a dial tone, and the display will show:

** Tel Mode **

_

Important: If you don’t hear a dial tone, make sure your fax machine is plugged into a working phone line.

1.8