Muratec F-120, F-150 Programmable one-touch keys, Using the power of programmable one-touch keys

Beyond the basics

print a report, make settings (including on the autodialer) or even make copies.

But the F-150’s and F-120’s TriAccess allows a minimum of three operations at once. For example, even if the machine is (1) printing a copy and (2) receiving into memory, it is

(3) still available for you to scan in documents for memory transmission.

Note: The F-100 does not have TriAccess; however, it does have dual access.

Programmable one-touch keys

Using the power of programmable one-touch keys

The programmable one-touch keys P1–P12simplify complex fax operations, letting you really tap into your machine’s power.

Note: Toggle between the two sets of programmable keys, P1–P6and P7–P12,by turning the fliptab back and forth; whichever set is visible is ready for use.

You can “teach” these keys the following multi-step operations for one-keypress con- venience (the pages shown contain instructions for the specific operations):

•Delayed transmission (pages 2.21–2.23)

•Broadcasting (pages 2.18–2.20)

•Relay broadcast initiation (pages 2.19–2.20)

•SecureMail transmission (pages 2.46–2.49)

•Polling, regular and database (not continuous) (pages 2.31–2.33)

•Batch transmission (pages 2.24–2.27)

There is a great deal of similarity among how you set the various operations; but, for your convenience, we’ll give you full instructions for each one. Just FYI, however, we’ll summarize by saying that, each time, you tell the machine four simple things:

•How — The key you’re programming

•Who — The number(s) the machine should dial

•What — The operation it should perform

•When — The date(s) and time(s) when you want it to perform the operation.

Programming a delayed transmission

Note: To erase a programmable one-touch key, refer to page 2.43.

To program a delayed transmission into a programmable one-touch key:

1 Press /PROGRAM, C, 1, ENTER. The LCD either shows:

Select Program No.

… or indicates a command already is programmed into this key.

If P01 is the key you want to program, skip to step 3. (However, our examples from here will say “P08” rather than “P01.”)

2.36