Muratec F-120 Autodialing while using the PIN mask, PIN Mode Mode1, Set PIN Number, 001PIN Number

5	To change the setting, press or /PROGRAM repeatedly until your desired
	setting appears. In this example, we’ve chosen “Mode1.”

PIN Mode:

Mode1

6 Press ENTER.

Autodialing while using the PIN mask

Note: The following instructions presume you are familiar with how to set and use

your machine’s autodialer. If you need to review, see pages 2.8–2.16.

Note: If the PIN mask feature is off, you use the autodialer normally.

If you’ve specified “Mode 1” — the PIN goes in

In this mode, before autodialing the desired number the first time, you must add the PIN to its stored one-touch key or speed-dial number. Here’s how:

1 Make a normal autodialer entry through the entry of the call group(s). The LCD will show:

Set PIN Number

2 Use the numeric keypad to enter the four-digit passcode. Here, we’ll use our sample passcode again.

Set PIN Number

3 Press ENTER. In our example, we’re setting speed-dial number 001:

001:PIN Number

_

4 Use the numeric keypad (including either * or #, if necessary) to enter the desired PIN, up to eight characters in length.

001:PIN Number 1057_

Beyond the basics

5 Press ENTER to save the PIN.

Note: If you press ENTER without entering the PIN, the fax machine beeps, indicates “Invalid Number” on the LCD and then returns you to step 3.

Now you may autodial the number as usual.

Important: While in PIN Mode 1, any autodialer numbers you use must include the PIN. Thus, this applies also to autodialer numbers used with batch transmission (see pages 2.24–2.27) or programmable one-touch keys (see pages 2.36–2.43).

Note: If you select either Mode 1 or Mode 2 and will be using batch transmission (see pages 2.24–2.27), you must store the PIN access code for the remote unit within the appropriate batch box.

If you’ve specified “Mode 2” — as you autodial, load the code

In this mode, you don’t have to add the PIN to the autodialer setting itself. Instead, you enter the PIN manually each time you autodial:

1 Perform the usual autodialing procedure for the number itself. Here, we’ve pushed one-touch key A:

Press Start

A_

2 Press START. The machine now asks for the PIN:

Enter PIN Number

_

3 Use the numeric keypad to enter the PIN.

Enter PIN Number 1057_

4 Press START. Your machine will dial the number.

Note: If you select either Mode 1 or Mode 2 and will be using batch transmission (see pages 2.24–2.27), you must store the PIN access code for the remote unit within the appropriate batch box.

2.51