Muratec F-150, F-100 Programmable one-touch fax dialing, Erasing a programmable one-touch key

Press ENTER.

Select Program No. P10:Polling

3 If you change your mind and wish to erase a different programmable one- touch key, just press that key before going on step 4.

4 Press ENTER. The LCD shows:

Erase P One-Touch Check Program/Enter

Select Program No. P01:Delayed

If P01 is the key you want to erase, skip to step 3. (However, our examples from here will say “P10” rather than “P01.”)

2 Press the programmable one-touch key you want to erase. Here, we’ve selected P10:

Press /PROGRAM, C, 2, ENTER. The LCD shows something like:

4 Do not enter any characters here (if you do, you can’t program a batch trans- mission into this key). Instead, only press ENTER and then proceed to step 5.

P07:Fax Number

_

Note: If you accidentally enter any characters here, press CANCEL as many times as needed to erase all of them before you proceed to step 5.

Note: If this key already holds a batch transmission, skip to step 6.

5 Press COMMUNICATION OPTIONS five times and then press ENTER. The LCD shows:

Batch Tx

Enter Box No. _

6 Use the numeric keypad to enter the one-digit identifier for the batch box you wish to assign to this one-touch key. Here, we’ve entered 5:

Batch Tx

Enter Box No. 5_

Note: To change an identifier already entered, press CANCEL to erase it. Then re-enter until the entry is just as you want it.

7

8 The LCD now displays the next programmable one-touch key.

If you do not wish to enter or change any other key’s programming, press STOP to return your machine to its usual standby mode.

If you do wish to enter or change this key’s programming, go back to step 3. If you wish to enter or change another key’s programming, go back to step 2.

Programmable one-touch fax dialing

To dial a fax call using a programmable one-touch number:

1 Insert the document.

2 Adjust resolution and contrast if necessary.

3 Toggle between transmission from the feeder or from memory if necessary, by

pressing MEMORY TRANSMIT.

4 Press the programmable one-touch key in which you’ve stored the number.

Your fax will perform the operation either now or at whatever other time you set.

Note: To review each available operation’s details, please review its appropriate instructions. See page 2.36 for a list of where you may find each operation.

Beyond the basics

If you programmed this key to delay its operation, the LCD will show:

** Reserved **

A4 Memory 95%

However, if you programmed this key to perform the operation immediately after the keypress, the LCD will show the number:

9-1-972-555-4335

A4 Normal

Erasing a programmable one-touch key

1

Important: If you want to quit without erasing the programmable one- touch key you’ve selected, press /PROGRAM. The fax will return to step 2.

5 Press ENTER to erase the number.

Erase P One-Touch ** Complete **

To erase another programmable one-touch key, repeat steps 2–5. Or press STOP to return to standby mode.

2.43