GE GFK-1541B manual Installing an IC693CMM321 Ethernet Interface Module

2

Installing an IC693CMM321 Ethernet Interface Module

The IC693CMM321Ethernet Interface mounts in a Series 90-30 PLC baseplate. It connects to an Ethernet network either directly through its 10Base-T port (10Base-T Type only), or through its AAUI port, which requires a user-provided transceiver and cable. If using the AAUI port, you may order a transceiver from GE Fanuc (see Appendix B for information) or supply your own equivalent transceiver. .

IC693CMM321 Series 90-30 TCP/IP Ethernet Interface (10Base-T Type)

CMM321 versions EF or earlier do not have a 10Base T port.

CMM321	OK	OK
ETHERNET	LAN	LAN
INTERFACE	FDX	FDX
	STAT	STAT

ETHERNET
RESTART	RESTART
	PUSHBUTTON
STATION
MGR
RS-232	RS-232 STATION
	MANAGER
	PORT (RJ-11)

10BASE-T

10BASE-T PORT (RJ-45)

Serial Number

Label (Internal)

Default Station

Address Label

(Internal)

AAUI PORT

This module has several user-accessible features:

ƒFour LEDs are located at the top of the board.

ƒThe Restart pushbutton is located immediately below the LEDs.

ƒThe Station Manager port (RS-232 serial port with an RJ-11 connector) is located on the front of the module.

ƒThe 10Base-T Ethernet port (RJ-45 connector) is located on the front of the module. It does not require an external transceiver.

ƒThe AAUI port (14-pin AAUI connector) is accessible through an opening in the bottom of the module. It requires an external transceiver.

ƒThe Default Station Address label lists the MAC address to be used by this Interface. It is located by removing the module’s front cover and looking on the circuit board.

ƒThe module’s serial number is on the silver label on the left side of the module.

2-2 TCP/IP Ethernet Communications for the Series 90™ PLC User's Manual– May 2002 GFK-1541B