GE GFK-1541B manual CPU364 Configuration Parameters Ethernet Parameters

2

Configuring the Interface Using the Logicmaster 90-30 Configuration Software

To configure the Ethernet Interface, access the I/O Configuration rack screen in the Logicmaster

90-30 Configuration Package, and do the following:

1. Move the cursor to the CPU slot (slot1) and press Zoom (F10) to access the CPU configuration screen.

2. If the current CPU is the CPU364, continue to step 3. Otherwise, press CPU (F1) to access the CPU selection menu. Use the arrow keys to highlight the CPU364 (IC693CPU364), press Enter to select it, and then press Y to replace the module.

3. The initial configuration screen contains the actual CPU configuration parameters. Press Page Down to access the configuration screens for the Ethernet Interface (Ethernet parameters and RS-232 serial port parameters).

4. Configure the Ethernet parameters. Refer to the topic “Configuration Parameters” that follows for more information on these fields.

5. Optionally, after you have assigned the Ethernet parameters, press Page Down to display the serial port parameters. You can then change the default settings of the serial ports (optional). Refer to the topic “Configuration Parameters” that follows for more information on these fields. We recommend leaving the serial port parameters at default settings.

6. After you have completed the configuration, press the Escape key to return to the rack display. Press Escape again to save the configuration to disk.

7. Store the configuration to the PLC so these settings can take effect.

Refer to GFK-0466,Logicmaster 90 Series 90-30/20/Micro Programming Software User’s Manual for more information on configuring the Ethernet Interface using Logicmaster 90-30 software.

CPU364 Configuration Parameters

Ethernet Parameters

Configuration Mode: This is fixed as TCP/IP.

Adapter Name: A symbolic name representation of the associated IP address. The character set is listed in Chapter 6, “Network Administration Support”. The Adapter Name is associated with the IP address used in Ethernet Global Data. If supported in the PLC programming software, view all adapter names in Hardware Configuration by going to the Edit menu, choosing Rack Operations, and selecting Name Resolution. Adapter names are listed in the Adapter Names tab.

Status Address: The Status Reference Type is the location of the LAN Interface Status (LIS) bits (16 bits) and the Channel Status bits (64 bits). The Channel Status bits are always located immediately following the LAN Interface Status bits. The Status address can be assigned to %I, %Q, %R, %AI or %AQ memory. The default value is the next available %I address.

Note

Do not use the 80-bits assigned to the LIS bits and Channel Status bits for other purposes or your data will be overwritten.

GFK-1541B Chapter 2 Installation 2-23