2 |
Installing the CPU374 in the PLC
For general information about module and system installation, refer to
Equipment Required to Perform the Installation Procedures
Make sure you have the items listed below before you begin.
A Series
PLC programming software: Logic Developer Version 2.60 or higher, Control Version 2.01 or higher, or VersaPro version 2.03 or higher. (And a compatible
computer.)
Ethernet cables.
A serial cable for the Station Manager port on the Ethernet Interface (see Appendix B).
Optional
A terminal or
Note
If your installation requires CE Mark compliance, please refer to
CPU374 Installation
Use the following instructions as a guide when inserting a module into a slot in a baseplate.
These instructions assume that the power supply on the baseplate is to your left.
Warning
Do not insert or remove modules with power applied. This could cause the
PLC to Stop, damage the module, or result in personal injury.
1. Be sure the Series
2. Align the module with the CPU’s base slot (slot 1) and connector. Tilt the module upwards so that the top rear hook of the module engages the slot on baseplate.
3. Swing the module downward until the connectors mate and the
4. Visually inspect the module to be sure that it is properly seated.
5. Connect one or both of the Ethernet ports on the Ethernet Interface to the network.
6. Restore power to the baseplate.
7. Use the PLC programming software or a Hand Held Programmer to make sure the PLC CPU is in Stop mode.
TCP/IP Ethernet Communications for the Series 90™ PLC User's Manual– May 2002 |
|
