GE GFK-1541B manual Pinging TCP/IP Ethernet Interfaces on the Network

2

Pinging TCP/IP Ethernet Interfaces on the Network

PING (Packet InterNet Grouper) is the name of a program used on TCP/IP networks to test reachability of destinations by sending them an ICMP echo request message and waiting for a reply. Most nodes on TCP/IP networks, including the Series 90-30 CPU364, implement a PING command.

You should ping each installed Ethernet Interface. When the Ethernet Interface responds to the ping, it verifies that the interface is operational and configured properly. Specifically it verifies that acceptable TCP/IP configuration information has been stored to the Interface.

Pinging the Interface from a UNIX® Host or a PC Running TCP/IP Software

A ping command can be executed from a UNIX host or PC running TCP/IP (since most TCP/IP communications software provides a ping command) or from another Ethernet Interface.* When using a PC or UNIX host, the user can refer to the documentation for the ping command, but in general all that is required is the IP address of the remote host as a parameter to the ping command. For example, at the command prompt type:

ping 10.0.0.1

Determining If an IP Address Has Already Been Used

It is very important not to duplicate IP addresses. To determine if you have configured your Ethernet Interface with the same IP address as another node:

1.Disconnect your Interface from the LAN.

2.Ping the disconnected Interface’s IP address. If you get an answer to the ping, then the chosen IP address is already in use by another node. You must correct this situation by assigning unique IP addresses.

*To use another GE Fanuc Ethernet Interface, refer to the PING command in GFK-1186, TCP/IP Ethernet Communications for the Series 90 PLC Station Manager Manual.

® UNIX is a registered trademark exclusively licensed through X/Open Company LTD.

GFK-1541B Chapter 2 Installation 2-29