GE GFK-1541B manual IC649AEA103 Ethernet 10Base2 Transceiver, LED Indicator Light

B

IC649AEA103 Ethernet 10Base2 Transceiver

Note: This transceiver replaces catalog number IC649AEA101

•Compliant with the IEEE 802.3 Ethernet specification for 10Base2.

•A standard BNC connector is mounted on the body of the transceiver for connection to thin coaxial Ethernet cable

•This unit has an attached 10” (254 mm) cable with standard 14–pin AAUI connector for connecting to a Series 90–30 Ethernet module (IC693CMM321) or CPU with Ethernet interface (IC693CPU364).

•SQE slide switch is set to enabled position at the factory. It must be in this position for proper operation with GE Fanuc Ethernet products IC693CMM321 and IC693CPU364 (see figure below).

•Power LED indicator light.

0.9"		3.2 inches (81 mm)			10 inches (254mm)
(23	mm)		Slide	Switch in this Direction to Enable

SQE Slide Switch (recessed in

14-Pin AAUI

Connector

2 inches

(51 mm)

7 6 5 4 3 2 1

BNC Connector	Green LED	8	9	101112 13 14
	Power

Power Requirement

This unit draws 400 mA @ 5Vdc from the Ethernet Interface via the AAUI connector.

LED Indicator Light

Located on the side of the unit as shown above. This green LED turns on to indicate the presence of 5Vdc power to the unit.

GFK-1541B Appendix B Communications Port Characteristics B-17