Muratec F-150 Programming a broadcast, Select Program No, P08Fax Number, 9-5558743, Delayed, 2.37

Press ENTER, ENTER.

2 Select the key in which you want to program a command or change a previ- ously stored command — if necessary, turn the fliptab to see it, as described earlier — and then press it. Here, we’ve selected P08.

Select Program No.

3 If you change your mind and wish to select a different programmable one- touch key, go back to step 2 before going on to step 4.

4 Press ENTER. The LCD now shows either

P08:Fax Number	or	P08:Fax Number
_		9-5558743_

5 Use the numeric keypad to enter the number exactly as your machine should dial it, including whatever codes your phone system may require. The num- ber can be up to 40 characters in length:

P08:Fax Number 9-5550629_

Your display can show only 20 characters at a time. To view characters beyond those 20 (such as with an international long-distance number), press to scroll leftward or /PROGRAM to scroll rightward.

Important: Do not press ENTER.

Note: If you make a mistake or want to erase characters entered in a previ- ous setting, press CANCEL to erase leftward. Or, if you want to change just one character in the number, press to move the cursor leftward, or /PROGRAM to move it rightward, to that character. Then re-enter until the number is just as you want it.

6 Now, while you still can see the fax number on the LCD, press

COMMUNICATION OPTIONS, ENTER. The LCD shows:

Delayed

Beyond the basics

7 There’s a choice to make. Instruct your fax to carry out this delayed command in one of the following ways:

Option 1: Perform the command once at a certain time on a certain day of the month. (For example, “Do this at 5:05 PM on the 30th.”)

To select this option, use the numeric keypad to enter the date and time when the fax should perform the command:

Delayed

Option 2: Perform the command at a certain time each day you press the key. (For example, “Do this at 5:05 PM today.”)

To select this option, use the numeric keypad to enter 0, 0 (i. e., 00), and then the time when the fax could perform the command:

Delayed

8

9 The LCD now displays the next programmable one-touch key.

If you do not wish to enter or change any other key’s programming, press STOP to return your machine to its usual standby mode.

If you do wish to enter or change this key’s programming, go back to step 3. If you wish to enter or change another key’s programming, go back to step 2.

Programming a broadcast

Note: To erase a programmable one-touch key, refer to page 2.43.

Programming a broadcast is very similar to programming a delayed transmission except that, rather than specifying just one phone number, you set up multiple numbers to which the transmission should go.

To program a broadcast into a programmable one-touch key:

1 Press /PROGRAM, C, 1, ENTER. The LCD either shows:

Select Program No.

… or indicates a command already is programmed into this key.

If P01 is the key you want to program, skip to step 3. (However, our examples from here will say “P06” rather than “P01.”)

2.37