Husqvarna Rider 16 manual Maintenance schedule, Daily, Maintenance interval, Page, in hours

MAINTENANCE

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For the items which are not described in these instructions go to an authorised service workshop.

		Daily	Maintenance interval
Maintenance	Page	maintenance		in hours
		before start	25	50	100
Check the engine’s oil level	38	●
Check the engine’s cooling air inlet	27	●
Check the fuel pump’s air filter	25	●
Check the steering wires	22	●
Check the battery	25	●
Check the safety system	26	●
Check screws and nuts	–	❍
Check for fuel and oil leakage	–	❍
Change the engine oil 1)	38		●
Clean the air filter’s pre-filter (foam plastic) 2)	24		●
Check the cutting unit	29		●
Check the tyre pressures (60 kPa)	27		●
Lubricating the belt adjuster 3)	39		●
Lubricate joints and shafts 3)	39		●
Check the V-belts	–		❍
Check the hydrostat’s cooling fins	–		❍
Check the transmission’s oil level	39			●
Adjust the brakes	22			●
Check and adjust the throttle wire	23			●
Clean the engine’s and hydrostat’s cooling flanges 2,4)	–			❍
Replace the air filter’s pre-filter and paper filter 2)	24				●
Replace the fuel filter	23				●
Replace the plug	–				❍

1)First change after 5 hours. 2) During dusty conditions cleaning and replacement should be more frequent. 3) For daily use of the machine lubrication should be conducted twice a week. 4) Conducted by authorised service workshop.

●= Described in these instructions.

❍= Not described in these instructions.

WARNING!

No service procedures must be conducted on the engine or cutting unit unless:

•	The engine is switched off.	•	The parking brake is applied.
•	The ignition key is removed.	•	The cutting unit is disengaged.

•The ignition cable is removed from the plug.

20 – English