Installation and Service Instructions
640 Series Rotary Sprinkler
Installation Procedure
To assure maximum performance from your 640 Series Rotary Sprinklers, read these instructions completely prior to installing or servicing the sprinkler.
Construct Swing Joints
1.Construct triple swing joints for each sprinkler as shown in Figure 1. Use PVC or ABS pipe nipple for sprinkler connection.
Note: On sites where the possibility of heavy equipment rolling over a sprinkler exists, the swing joint will flex preventing damage to the lateral or main lines. On a new installation in raw ground where the sprinklers are to be initially installed above the finished grade and lowered when new turf is established, the swing joint allows sprinkler repositioning without changing risers. This is a common and practical procedure which eliminates the problem of dirt being accidentally introduced into the lateral lines when a riser is changed.
2.Flush lines thoroughly prior to installing sprinkler.
3.Apply Teflon™ tape on riser threads. Install sprinkler to riser and tighten.
FIGURE 1 |
0 |
CAUTION
Use only Teflon tape on riser threads. Use of pipe dope or other types of sealing compounds can cause deterioration of plastic threads and components.
4.Install sprinkler on riser. Align
5.
6.Install sprinklers flush with grade to 1/2 in.
7.Backfill and compact soil around sprinkler avoiding contact with nozzle assembly.
Servicing the Sprinkler
Valve Replacement
WARNING
POSITIVELY SHUT OFF WATER SUPPLY AT SOURCE PRIOR TO DISASSEMBLING SPRINKLER. BLEED ALL PRESSURE FROM SPRINKLER SYSTEM INCLUDING CONTROL TUBES. FAILURE TO DEPRESSURIZE SYSTEM PRIOR TO VALVE SNAP RING REMOVAL MAY CAUSE VALVE MECHANISM TO FORCIBLY EJECT FROM SPRINKLER BODY RESULTING IN POSSIBLE SERIOUS INJURY.
1.Remove cap set screw with 1/8 in. hex wrench and unscrew cap.
2.Remove nozzle container seal, nozzle retainer and nozzle/drive assembly from body.
3.Depress valve mechanism using a long screwdriver or similar tool (see CAUTION below).
CAUTION
Do not continue valve removal procedure if the valve cannot be pressed down with minimum force. Confirm that water pressure is off and the control tube is bled before continuing.
Body
Snap
Ring
Valve |
1