SECTION 12: TROUBLESHOOTING
Trouble | Possible Cause(s) | Corrective Action |
|
|
|
Engine fails to start | PTO (Blade Engage) lever engaged. | Place PTO (Blade Engage) Lever in disengaged (OFF) |
| Parking brake not engaged. | position. |
| Spark plug wire(s) disconnected. | Engage parking brake. |
| Throttle/choke control not in correct | Connect wire to spark plug. |
| starting position. | Move Throttle/Choke Control into CHOKE position. |
| Choke not activated | Move Throttle/Choke Control into CHOKE position. |
| Fuel tank empty, or stale fuel. | Fill tank with clean, fresh (less than 30 days old) gas. |
| Blocked fuel line. | Clean fuel line or replace fuel filter. |
| Faulty spark plug. | Clean, adjust gap or replace plug. |
| Engine flooded. | Crank engine with throttle in FAST position. |
Engine runs erratic | Unit running with CHOKE activated. | Move Throttle/Choke Control out of CHOKE position. |
| Spark plug wire(s) loose. | Connect and tighten spark plug wire(s). |
| Blocked fuel line or stale fuel. | Clean fuel line; fill tank with clean, fresh (less than 30 |
|
| days old) gasoline. Replace fuel filter, if so equipped. |
| Vent in gas cap plugged. | Clear vent or replace cap if damaged. |
| Water or dirt in fuel system. | Drain fuel tank. Refill with clean, fresh (less than 30 |
|
| days old) gasoline. |
| Dirty air cleaner. | Replace air cleaner paper element or clean foam |
|
| precleaner. |
Engine overheats | Engine oil level low. | Fill crankcase with proper capacity and weight of oil. |
| Air flow restricted. | Clean grass clippings and debris from around the |
|
| engine’s cooling fins and blower housing. |
Engine hesitates at high RPM | Spark plug gap too close. | Remove spark plug and reset the gap. |
Idles poorly | Spark plug fouled, faulty or gap too | Replace spark plug. Set plug gap. |
| wide. |
|
| Dirty air cleaner. | Replace air cleaner element or clean |
Excessive vibration | Cutting blade loose or unbalanced. | Tighten blade and spindle. Balance blade. |
| Damaged or bent cutting blade. | Replace blade. |
Mower will not mulch grass | Engine speed too low. | Place throttle in FAST (rabbit) position. |
| Wet grass. | Do not mow when grass is wet; wait until later to cut. |
| Excessively high grass. | Mow once at a high cutting height, then mow again at |
|
| desired height or make a narrower cutting swath. |
| Dull blade. | Sharpen or replace blade. |
Uneven cut | Deck not balanced properly. | Perform |
| Dull blade. | Sharpen or replace blade. |
| Uneven tire pressure. | Check tire pressure in all four tires. |
29
