Toshiba specifications 2.0kVA Industrial Rackmount

Black Gold Single Phase Uninterruptible Power Supply Systems Guide Specifications

2.0kVA Industrial Rackmount

1.0Scope

This specification describes the requirements for an On-Line Uninterruptible Power Supply (UPS). The UPS will supply a computer grade AC output sinewave which is unaffected by the quality of the AC input. The input voltage shall be single phase with the output voltage being single phase.

2.0General Operation

Under normal operating conditions, the UPS's rectifier converts alternating current (AC power) to direct current (DC power), which is required for the system's inverter and battery charger. The charger supplies regulated DC power to keep the batteries constantly charged. The inverter uses pulse width modulation (PWM) that fully utilizes the characteristics of insulated-gate bipolar transistors (IGBT) to convert DC power to regulated AC power. Therefore there is a constant supply of power. The batteries will instantaneously supply the inverter DC power should an AC power line failure occur.

2.1Performance Standards

The UPS shall be designed with the applicable sections of UL, CSA, NEMA PE-1, and IEEE-587(ANSI C62.41). The UPS shall have UL 1778 listing and is CUL certified..

3.0General

3.1Materials

All materials used are of new manufacture using the latest technology and should not have been in prior service except for specified factory testing. IGBT's (insulated-gate bipolar transistors) are used exclusively in inverter and chopper sections.

3.2Components

All functioning components are solid state with no moving parts.

3.3Installation

The installation of the UPS must comply with the UPS manufacturer's recommendations that will be supplied before delivery of the UPS. Local electrical codes and the National Electric Code must be complied with. All wiring must comply exactly with what is specified.

3.4Assembly

The UPS shall be delivered fully assembled and be fully functional.

Line Cord:	5-20P
Receptacle Panel:	Six 5-15R (120V In / 120V Out)
	Six IEC 320 (230V in / 230V Out)

4.0System Theory and Operation

4.1Theory

AC input from the utility system is converted into DC power by a diode bridge rectifier and stepped up by the chopper. The stepped up DC power is then converted to AC power by the inverter. The output voltage waveform of the inverter will be the pulse voltage

Page 1 of 5