Programming the remote control to operate a
Your Toshiba TV remote control is preprogrammed to operate Toshiba brand VCRs and cable TV converters. To program your TV remote control to operate a
Introduction
RECALL MUTE
o
POWER
RECALL
POWER
1 In the code table on page 14, find the code for your brand of VCR or cable TV converter.
If more than one code is listed, try each one separately until you find one that works.
Connecting your TV
1 2 3
4 5 6
7 8 9
CH RTN
100 0 ENT
CH
VOL MENU/ VOL
ENTER
CH
TV
CABLE
VCR EXIT
FAV CH TV/VIDEO
A
REC TV/VCR STOP PLAY
STILL SOURCE PIP
SLOW PAUSE REW FF
PIP CH 
LOCATE SWAP
Channel Numbers
2 Set the TV/CABLE/VCR switch to VCR (for a VCR), or CABLE (for a cable TV converter).
3 While holding down RECALL, press the Channel Number buttons to enter the
4 To test the code, turn the VCR or converter on, point the remote control at it, and press POWER.
–If the correct code was entered, the VCR or converter will turn off.
–If the VCR or converter does not respond, repeat steps 1Ð4 using another code.
–If the VCR or converter does not respond to a different code, you will need to use the remote control that came with your VCR or converter.
5 Set the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the code(s) you used:
VCR Code:
Cable TV Converter Code:
Note:
You must reprogram the remote control every time the batteries are changed.
Some newer VCRs respond to either of two codes. These VCRs have a switch labeled ÒVCR1/VCR2.Ó If your VCR has this kind of switch and does not respond to the codes for your VCR brand, set the switch to the other position (ÒVCR1Ó or ÒVCR2Ó) and reprogram the remote control.
Using the Remote Control
Setting up your TV
Using the TVÕs Features
Appendix
13
