Toshiba 72HM196 manual Using the remote control to operate your other devices, Device code setup

HM196_EN.book Page 16 Tuesday, May 30, 2006 2:18 PM

Chapter 2: Using the remote control

Using the remote control to operate your other devices

Your TV remote control has one dedicated TV mode and three programmable multi-brand modes: CABLE/SAT, DVD, and VCR/PVR. The default device modes and programmable device modes are listed below.

Note: The TV remote control is preprogrammed to operate most Toshiba devices. To operate a non-Toshiba device or a Toshiba device that the remote control is not preprogrammed to operate, you will need to program the remote control. See “Programming the remote control to operate your other devices” (at right).

MODE SELECT Default device mode control (before programming)

TV	Toshiba TV
CABLE/SAT	Toshiba DST 3100 Satellite receiver
DVD	Orion DVD
VCR/PVR	Toshiba VCR

MODE SELECT Device mode control after programming

TV	Toshiba TV
CABLE/SAT
DVD	Multi-brand video/audio devices
VCR/PVR

Note: Although your new TV’s remote control includes codes for many devices, it may not include codes for some or all of the features on certain devices you wish to control. If you are unable to program the TV’s remote control to operate your device or some of the features on that device, use the device’s remote control or the controls on the device.

Programming the remote control to operate your other devices

Device code setup

1 Find the code for your device brand in the remote control device code table on pages 18–21.

If more than one code is listed, try each one separately until you find one that works.

2 Press the applicable mode select button (CABLE/SAT, DVD, or VCR/PVR), until the device button LED blinks 3 times.

3 While holding down E, press the Number buttons to enter the device category code “0–5” shown below plus the four-digit code for your device.

Category	Device code
TV (Toshiba)	0
Cable box
Satellite receiver	1
Cable/PVR combo
DBS/PVR combo (1)
DVD	2
VCR
PVR	3
DBS/PVR combo (2)
Audio Amp	4
Audio Amp/Tuners
CD player	5

•If a valid code is entered, the device button LED will blink twice.

•If an invalid code is entered, the device button LED will blink one long blink.

4 Point the remote control at the device and press pto test the code.

•If the device responds to the remote control, you have entered the correct code.

•If the device does not respond to the remote control, repeat steps 3 and 4 using another code.

Note: After programming the remote control, make sure all necessary keys on the TV remote control (in addition to p) operate your device. If some keys are not operational, repeat the device code setup using another code (if other codes are listed for your device). If, after trying all listed codes, the necessary keys do not operate your device, use the device’s original remote control.

16

HM196 (E/F) Web 213:276

Downloaded from www.Manualslib.com manuals search engine