Toshiba 72HM196 Setting up your TV, Selecting the menu language, To select the menu language

HM196_EN.book Page 25 Tuesday, May 30, 2006 2:18 PM

Chapter 4: Setting up your TV

Selecting the menu language

You can choose from three different languages (English, French, and Spanish) for the on-screen display of menus and messages.

Note: The TV Guide On Screen™ menus are in English, regardless of the language selected in this menu.

To select the menu language:

1	Press Yand open the Preferences menu.
2	Highlight Menu Language and press c.
3	Press B or b to select your preferred menu language and
	press T.
		Preferences
		Closed Caption Mode	Off		English
		Closed Caption Advanced			Français
		Input Labeling			Español
		Menu Language English
		Channel Browser Setup
		Navigate ENTER Select		CH RTN Back EXIT Exit

4 Press Oto close the Preferences menu.

Configuring the antenna input sources for the ANT 1 and ANT 2 terminals

To configure the ANT 1 and ANT 2 input sources:

1 Press Yand open the Setup menu.

2 Highlight Installation and press T.

Setup

Installation
Sleep Timer
On/Off Timer
ColorStream HD1 Audio	No
HDMI 1 Audio	Auto
ColorStream HD2 Audio	No
HDMI 2 Audio	Auto
Navigate ENTER Select	CH RTN Back EXIT Exit

3 (A new set of Installation menu icons will appear, as shown below.) Open the Terrestrial menu, highlight Input Configuration, and press T.

Note: The Terrestrial menu may not be accessible (items will be “grayed out”) in some instances (for example, if a cable box is connected to the ANT 1 input or if one of the VIDEO modes is the current input during TV Guide

On Screen™ setup).

Terrestrial

Input Configuration

Channel Program

Channel Add/Delete

Signal Meter

Navigate ENTER Select CH RTN Back EXIT Exit

4 Press B or b to highlight Antenna 1 In, and press C or c to select the input source (Cable or Antenna) for the ANT 1 input on the TV.

Note: If a cable box is connected to the ANT 1 input during TV Guide On Screen™ setup, the entire Terrestrial menu will not be accessible, including the input source for ANT 1, which will automatically display “Cable Box.”

5 Press b to highlight Antenna 2 In and then C or c to select the input source (Cable or Antenna) for the ANT 2 input on the TV, if applicable. If you have not connected anything to the ANT 2 input, skip this step.

Input Configuration

Antenna 1 In	Cable
Antenna 2 In	Antenna

CancelDone

6 To save your new settings, highlight Done and press T. To revert to your original settings, highlight Cancel and press T.

25

HM196 (E/F) Web 213:276

Downloaded from www.Manualslib.com manuals search engine