MX196_EN.book Page 2 Tuesday, June 27, 2006 1:43 PM

CAUTION: This television is for use only with the Toshiba stand indicated below. Use with other carts or stands is capable of resulting in instability, causing possible injury.

Television

Stand Model

62MX196

ST 6296

72MX196

ST 7296

FCC Declaration of Conformity Compliance Statement

(Part 15):

The Toshiba 62MX196 and 72MX196 Televisions comply with Part 15 of the FCC rules.

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The party responsible for compliance to these rules is: Toshiba America Consumer Products, L.L.C.

82 Totowa Rd. Wayne, NJ 07470. Ph: 1-800-631-3811

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by removing and applying power to the equipment, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications to this equipment not expressly approved by Toshiba could void the user’s authority to operate this equipment.

Important notes about your DLP® projection TV

1)The light source for this TV is a projection lamp unit with a limited service life. When the lamp wears out, the picture

may become dark or black or the lamp may fail, at which time you must replace the lamp unit (- “Lamp unit replacement and care” on pages 84–86).

2)When the lamp mode is set to Low Power, every time the TV is powered on, the lamp will initially be in High Bright mode but will switch to Low Power mode after a short period of time. You may notice a change in screen brightness

when this happens. This is normal and is not a sign of malfunction (- page 57 for details).

3)Every time the TV is powered on, it may take several minutes for the picture to obtain full brightness (- “IMPORTANT NOTICE ABOUT HOT LAMP RESTART,” on the next page).

4)The TV’s display is manufactured using an extremely high level of precision technology; however, an occasional pixel (dot of light) may show constantly on the screen. This is a structural property of DLP® (Digital Light Processing®) technology and is not a sign of malfunction. Such pixels are not visible when the picture is viewed from a normal viewing distance.

5)Always sit approximately 10–25 feet away from the TV and as directly in front of it as possible. The picture quality may be affected by your viewing position and length of viewing time. If you sit too closely to the TV for too long, you may suffer from eye fatigue. See item 29 under “Care” on page 4 of the separate Installation Guide.

6)Depending on the media you are viewing, it is possible, although unlikely, that a limited number of viewers may see a “rainbow effect” on the screen, which can, in rare instances, result in eye fatigue. This is a rare occurrence related to DLP technology and is not a sign of TV malfunction.

7)This TV contains several cooling fans to moderate

the internal temperature. You may be able to hear the fans for several minutes after the TV is turned

off. This is a function of the Quick Restartfeature and is not a sign of TV malfunction. You can set the Quick Restartfeature to stop the fans as soon as the TV is powered off. See “Setting the Quick Restartfeature” (- page 30).

8)The yellow and blue LED lights at the bottom center of the

TV front indicate your TV’s current status. If either light flashes, see “LED indications” (- page 83).

9)Every time the TV power cord is plugged in, the yellow LED will blink until the TV enters standby mode (plugged in but not powered on). This is normal and is not a sign of malfunction.

2

MX196 (E/F) Web 213:276

Downloaded from www.Manualslib.com manuals search engine

Page 2
Image 2
Toshiba manual Part, Television Stand Model 62MX196 72MX196, This TV contains several cooling fans to moderate